Honeywell Solenoid valves for gaseous and liquid medium GB-series GB25

This range of solenoid valves is of high quality and suitable for universal application, and is not dependent on a specific minimum differential

pressure; the valves operate correctly with no pressure, at slight differential pressure, right,through to maximum pressure. They are therefore the valves of choice for installation in plants where differential pressures fluctuate greatly and are not possible to determine precisely in advance. The valves are also suitable for use in heating and cooling circuits

DN size mm: 25

Kvs value: 10

Connections: G1

Technical data

Type: 2/2-way

Operating mode: normally closed

Type of construction: Diaphragm solenoid valve, coupled. No initial pressure needed.

Materials: Casing: brass, internal parts: stainless steel

Alternatively: Casing: stainless steel 1.4410, internal parts: stainless steel

Sealing material: Perbunan (standard version), EPDM or FPM (Viton) available on request

Mounting position: Any, solenoid system preferably upright

Temperature of medium: -10°C to 90°C, Max. ambient temperature, 55°C Max. viscosity, Approx. 21 mm/s

Power consumption: 100 to 120 VA (start), 25 VA / 12 W (operation)

Operating frequency: Up to 50 cycles per minute, Duty cycle: 100% ED

Electrical connection: Angled plug to DIN43650

Voltage / current type: Standard version 230 V, 45–60 Hz

Special voltages available: Voltage, Code: 110 VAC   2,   24 VAC    8,  24 VDC     6

For example: GB 12–2 (2 = 110 VAC), Degree of protection, IP 65 according to DIN 40 050

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: