Auma Multi-turn actuators SA 07.2 – SA 16.2 Open-close
Non-Intrusive multi-turn actuators for open-close duty with integral controls AUMATIC
Type SA 07.2 – SA 16.2 with AC 01.2
Version according to wiring diagram TPC A-0A1-1C1-A000 TPA 00R100-3I1-000
- Type of duty: short-time duty S2-15 min
- Output speeds of 4 to 180 rpm at 50 Hz supply
- 3-ph AC motor in insulation class F, with motor protection by three thermoswitches placed in the windings
- Motor without terminal box, internal connection via plug/socket connector
- Anti-condensation heater in switch compartment, internal supply
- Electronic absolute encoder for position and torque sensing
- Handwheel does not rotate during motor operation, with output contact for manual operation
- Valve attachment according to EN ISO 5210
- Connection between actuator and controls via plug/socket connector
- Reversing contactors mechanically and electrically interlocked
- Local controls with operation mode switch, 4 push buttons, 6 indication lights, Bluetooth interface and plaintext display for programming, status, position and fault indication
- Four inputs OPEN - STOP - CLOSE - EMERGENCY 24 V DC galvanically isolated via opto-isolator
- Six freely programmable contacts for output signals on status and faults
- Programmable timer function
- Programmable emergency behaviour
- Programmable torque by-pass
- Galvanically isolated electronic position feedback signal 0/4...20 mA
- Galvanically isolated electronic torque feedback signal 0/4...20 mA
- Electronic device ID, event report, operating data logging and status signals according to NAMUR recommendation NE 107 via display
- Controls or local controls can be positioned at every 90°
- Permissible ambient temperature –25 °C to +70 °C, enclosure protection IP 68, corrosion protection KS
- Finish coating: 2-layer powder coating, colour: silver-grey (similar to RAL 7037)
Options:
- Corrosion protection KX, for installation in atmosphere with a high pollutant concentration
- Continuous mechanical position indication
- Wall bracket for mounting controls separate from actuator
Further options on request
Write a review
Your Name:Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below: