GE General Eastern pressure transmitter DPS 4000 – Digital Pressure Transducer

The DPS 4000 Series is a state of the art range of digital output pressure transducers featuring a CANbus serial communications interface.

Fully temperature corrected pressure readings are output as a digital word in any one of 24 engineering units, requiring no user system set-up or calibration. The integral digital electronics enhance performance to levels unmatched by traditional analog transducers.

Features:

Pressure Measurement
Operating Pressure Ranges Zero based ranges: 5 psi*, 10, 15, 30, 50, 100, 150, 300, 500 and 1000 psig (350 mbar, 700mbar, 1, 2, 3.5, 7, 10, 20, 35, 70 bar), absolute or differential.

Bi-directional gauge and differential ranges available on request.

*5 psi gage, or differential only
 
Overpressure The pressure range can be exceeded by the following with negligible effect on calibration:
Positive side: 4 x full scale (FS) (2000 psi maximum) (140 bar maximum)
Negative side: 2 x FS (150 psi maximum) (10 bar maximum).
Line Pressure 500 psi (35 bar) maximum (differential model only).
Positive Pressure Media Fluids compatible with Stainless Steel 316 L and Hastelloy C276.
Excitation Voltage 7.5 to 30 VDC.
Output Configuration CANopen digital data via CANbus interface. User configurable pressure reading
Software Protocol In accordance with:

•DS301 V 4.01 (CANopen)
•DS404 V 1.0 (Analog input device profile)
•DSP 305 V 1.0 (Layer setting service)
 

Performance
Accuracy 0.2% reading down to 50% FS, then 0.1% FS to zero. Includes all errors over 50°F to 140°F (10°C to 60°C).
Long Term Stability Typically less than 0.08% FS per annum.
Operating Temperature Range -40°F to 175°F (-40°C to 80°C). Insulation Resistance Greater than 100 MΩ at 500 VDC
Mechanical Shock 1000 g, 1 mS half sine pulse in three mutually perpendicular axes will not affect performance.
Vibration Response <0.05% FS/g at 30 g peak 10 Hz to 2 kHz, limited by 0.5 in (12 mm) double amplitude.
Safety CE Marked
EMC emissions: EN 50081-1
EMC immunity: EN 61000-6-2

Physical
Weight 0.19 kg (7 oz) nominal.
Pressure Connection Male:

•G1/8B (60° Int Cone)
•G1/4B (60° Int Cone or Flat End)
•1/4 NPT
•7/16 UNF to MS33656-4
•M14 x 1.5
Female:

•G1/4,
•1/4 NPT
•Others available - refer to Druck.
 
Electrical Connection MIL-C-26482 six pin bayonet plug or six core shielded cable (3 ft. supplied as standard)

Alternatives available - refer to Druck.

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: