Kaneko solenoid valve 2 way
A solenoid valve Ni-po, in one place each valve, inlet and outlet piping is used ON the road, as the valve OFF.
Therefore, most products that use fluid pressure is generally low, less liquid 1.5MPa, 0.99MPa in the gas used in the following because it is used to directly control a liquid such as water, oil, chemicals, and gases such as air and gas is.
However, in our company, depending on the caliber, such as the type of fluid, there is also a production performance of the solenoid valve that can open and close the pressure more than 10MPa.
M22 SERIES
Feature
Since the pilot valve diaphragm and directly, you can use 0 or differential pressure.
Ⅱ B + H2T6 Exd explosion-proof explosion-proof test in Japan. It is available in a hydrogen atmosphere.
Mass flow rate can be obtained even in a small size.(CV value：Up to 13.0)
Precautions
Permissible tilt angle attachment is less than 30 degrees both left and right front and rear.
Standard specification
Fluid
Such as water, oil, air, inert gas
Working pressure
Air and gas 0～0.99MPa
Fluid temperature
－10℃～60℃(That it does not freeze)
Ambient temperature
－10℃～60℃(That it does not freeze)
Electrical ratings
Continuity
The allowable voltage fluctuation rate
＋10％，－15％
Current value
Following Table
WORKING PRESSURE
Insulation type H species
AC
DC
V/Hz
Start-up A
Power W
V
Excitation A
Power W
100V 50/60
0.15
16
12
1.03
18
110V 50/60
0.16
18
24
0.65
18
120V 50/60
0.17
21
48
0.33
18
200V 50/60
0.07
14
100
0.16
M30 SERIES
Feature
Pilot valve and main valve because it directly, you can use 0 or differential pressure.
For the same seat diameter and small diameter pressure loss is known.
We also manufacture certified high-pressure gas.
Precautions
Permissible tilt angle attachment is less than 30 degrees both left and right front and rear.
Standard specification
Fluid temperature
Be used up to 5 ~ 200 ℃ by the internal structure
Ambient temperature
-20～+40℃(That the fluid does not freeze but)
Fluid viscosity
250cst following
Electrical ratings
Continuity
The allowable voltage fluctuation rate
+10%，-15%
Current value
Following Table
M20 SERIES
Feature
Mass flow rate can be obtained even in a small size. (Cv value:Up to 12.6)
Mounting orientation freedom. (360 ℃)
VALVE,SOLN,1/4 IN PS,48 VDC 0.15 A 7.2 W
VALVE,SOLENOID:
PIPE SIZE:1/4 IN;
ORIFICE DIAMETER:5/16 IN;
ELECTRICAL RATING:48 VDC 0.15 A 7.2 W;
CONFIGURATION:4-WAY;
CONNECTION:NPT;
OPERATION:NO;
PRESSURE RATING:1.5 TO 10 BAR;
COIL:MOLDED;
ENCLOSURE:EXPLOSION PROOF/WATERTIGHT;
BODY MATERIAL: AL/STL;
ADDITIONAL DATA:
ANTI-SAND STORM, 2-POSITION, REFERENCE DWG # CS-3943AE, FOR AIR AND FLUID.
KANEKO SANGYO COMPANY LIMITED: P/N#MB15G-8-DE12PU
KANEKO SANGYO COMPANY LIMITED: DWG#CS-3943AE (H)
KANEKO SANGYO COMPANY LIMITED: Model#MB15G-8N-DE12PU
Precautions
For pilot-operated, should be able to ensure minimum operating differential pressure 0.05MPa or more times.
Standard specification
Fluid
Such as water, oil, air, inert gas
Working pressure
Gas 0.05～0.9MPa
Liquid0.05～1.6MPa
Differential pressure actuated
0.05MPa or more full-time
Fluid temperature
－20℃～60℃
Ambient temperature
－20℃～60℃(That the fluid does not freeze but)
Electrical ratings
Continuit
Showing 1 to 3 of 3 (1 Pages)
