SMC Electric Cylinders LECP6, Controller (Step Data Input Type), Step Motor (Servo/24 VDC) for LEM

Series LECP6 controller has two available modes for the setting software and teaching box.  In the easy mode, the operation can be started by only setting the speed, position, etc.  Using the normal mode allows a further detailed setup.  A few of the main functions of the LECP6 controller are actuator control, specified force operation, separated power supply, and returning the actuator to the home position by sending a single signal to a dedicated terminal. The LECP6 controls NPN or PNP step motors.

• Step motor controller (Servo/24 VDC)
• Compatible with series LEM
• Possible to set position, speed & force (64 points)
• Screw mounting or DIN rail mounting

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: